Skip to content
Hydra

Kits

A kit is a template for a set of pictures. It lists the shots the set needs (front, angles, back, bottom, open...), the fields that describe the product (size, colour, label size...) and the rules each shot must pass. A "product picture set, 360 degrees, 13 angles" template is a typical one.

Start a kit from a chat

  1. Give the chat your brief: the template's brief, the front and back label files (PDF is fine), and photos of the real product.
  2. The agent lists the templates (kit_templates), fills the fields from your brief (kit_create) and shows what it understood. Correct anything wrong before it runs.
  3. It starts the batch (kit_run). A Kit batch card appears in the chat with progress and an estimate; a set of 13 shots takes about a quarter of an hour. You can close the chat; the pictures arrive in the card by themselves.

Review on the board

The kit's board (Images, then the kit) shows every shot with its best score and the checks it failed, for example fill (the product too small or too large in the frame). For each shot you can:

  • approve the best try,
  • ask for another run,
  • or keep a shot from an earlier kit.

The agent can do the same from the chat (kit_status, kit_approve).

Stop, resume, export

  • Stop halts the batch between shots. Resume runs only the shots that still have no picture.
  • When the shots you need are approved, export the set (kit_export): a ZIP of 1080 px PNG files, an overview sheet and the brief.

Tips

  • Label files with a printer's cut line (a coloured border) confuse the model. Send the label without it.
  • Real photos of the side, bottom and open product make those shots far more accurate.
  • A kit redraws the product from your references. For a shop picture where the real photo must be used as it is, place it in a design instead.

Related